...gears jam tooth for tooth. Try moving the ribbon lift gear/cam on rt. side of the carrier by hand with the machine off if it won't move that's the trouble. Wiggle it back and forth and it may free
...jam, cn you help? ed This is from Lexmark Tech Chat ((IT WORKED)) The encoder strip is most likely the problem. Unplug the power from the printer. Open the front cover and move the cartridge carrier ...
...jam is occurring. Check to see if all the rollers are turning. If all the rollers are turning, there may be something in the feed path that you can't see. Go to step 6. If not, there is probably a ...
Question about Wheelwriter 6 Series II Typewriter
...form the ribbon is either empty of not lifting up. If it isn't lifting up there is a large black gear on the rt. side of the printer, wiggle it back and forth they sometimes jam tooth for tooth. ...
...tech support,,,your printer would be replaced if in warranty.. good luck Inside the printer by rollers belt fifteen inch piece like a ribbon comes out ON screen showing clear carrier JAM please ...
...print on the last page of the 3 part form has become very hard to read (very light). I changed the ribbon and have the form setting as high as it will go. No luck. any ideas? thank you Hi and
...print back and forth. How do I replace it Is it broken OR is there a little hook on the end of the ribbon? A broken ribbon will probably have a jagged or stretched end. If it is a hook of sume type, ...
...jam. Retrieved paper. Also out pops an eight-inch by 1/2 inch strip of ribbon probably designed to clean extra ink? Was jammed. Removed it. Now when printer is turned on, after a few seconds there is ...
Question about Wheelwriter 6 Series II Typewriter
I changed the ribbon and eraseribbon and now no ink will type Try typing on a multi part form, if the carbons don't print you probably have a broken print solenoid cap. Ifon the carbonse ribbon isn't ...
jam Check the fuser exit sensor flag. The sensor is on a p.c. board on the bottom of the fuser. Three things happen to it. Sometimes the board comes out of its clips and drops away from the sensor arm
Usually answered in minutes!
1,487 Questions
1,353 Questions
1,277 Questions
961 Questions
741 Questions
