...ribbon cable plugged into the Control Board. Very carefully remove the ribbon cable by squeezing the ribbon cable retainer plug ends to release the retaining plug which will then slide up the ribbon ...
Question about Neptune FAV6800AW Top Load Washer
...ribbon cable that plugs into the relay board. The ribbon cable is actually two cables pressed together, which can be seperated by simply lifting them apart. The ribbon cable has a defect in that the ...
...ribbon cable. It is the one that is white in color and has a small latch on it. try putting a piece of foam before putting the main board, such that the ribbon cable is held properly to the
...at one edge. Flip open the latch on the keyboard ribbon cable connector, and remove the cable. Lift the latch on the touchpad ribbon cable connector, and remove the cable. Remove the palm
...ribbon cable between the keyboard and the circut board and any switches controled by the latch which is more likely the problem.Also look for a loose wire on or near these switches. Good luck, ...
...ribbon cable on a 2555 lmt . My garmin froze on the garmin screen so then i tried to take it apart and change battery and when i did the ribbon came off the board .. For the life of me i cant figure ...
Question about P50H401 50 in. Plasma HDTV
ribbon cable of the buffer board, pull the cable out then put back in as even as possible line it up good. Then grab the cable with both hands and push it in kinda hard, but careful. then close latch.
Question about P50H401 50 in. Plasma HDTV
...ribbon cable partially out from its socket on the board. There is a locking latch at the connector that must be GENTLY pried up. Pull out the ribbon cable, reseat it into the connector as far as it ...
...ribbon cable that goes to the screen came lose from the main circuit board. I suggest you find a YouTube video on disassembling your tablet and watch it. Where the ribbon cable attaches to the board, ...
Question about Nuvi 1490LMT Nuvi 1490 w/ Lifetime Traffic & Maps ($349.99 before $70.00 savings)
...ribbon cable. Any suggestions? Resoldering is OK, but reinforcing the connector with a bonding material to prevent the connector from moving is also required. As for the LCD ribbon cable, there is a ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions