Questions & Answers for: rewind pull cord poulan model

...rewind the cord, re-attach cover & pull to start. Over & over. Finally will start, however, the cord is dangling out in the wind as I attempt to use the saw. Not Safe. Curious as if there is a method ...

...rewind on its own. If not check to make sure the spring is not broken. poulin engin will not turn over clutch seems ok as well as the pull starter polan 3300 cannot pull the cord, the chain and ...

...it's capacity before engaging the cord reel to the rewind spring. Good luck with it. These cords won't break if you use short pulls, preferably with your foot holding the right hand hold to the

...rewind the spring first, attach the new cord and wind it around the spool while holding the spring tension. After the cord is wound, feed the end out through the cord port and test for good return ...

rewind sticks pull rope ,rope stays out because rewind housing fits to tight Was the saw dropped on it's left side? Remove the entire starter housing and look for bent metal parts. Does the cord ...

Remove the starter and pull the cord, if the cord still only comes out so far it is either the cord is too short ( replace the cord ) or the rewind spring is coil bound ( release some of the tention

Do you have owners manual Need owners manual http://lawn-garden.needmanual.com/2010-poulan-p3816-chainsaw-owners-manual.html?d=df_m_en

Poulan chainsaw not getting any spark??? Tried switching coil with a working chainsaw and still got no spark new spark plug... checked filters all good... any ideas would be greatly appreciated thanks

cord and gas still comes out exhaust. With the exaust in the direction of the ground not using primerbulb and sparkplug removed as you must draining the crankcase from the fuel surplus , take a stroke

Need to know gas/oil mix for Poulan gas chainsaw model P3816 40 to 1