Question about 2001 Santa Fe
...high revs for at least a minute before it isnt a problem anymore, and it never happens again until the next fill up. I have even tried stopping the pump myself instead of letting it stop itself ...
...revs and the RPM's seem to go high to about 3700-4000 RPM's before it shifts the first time. If I am going up a hill and press the gas to accelerate, it seems like it's hard for the car to accelerate ...
pressing down the gas hard, very limited power at low rev's (<2000 rpm) and it could not pull away at any slight incline without stalling. The Toyota dealership where I bought it offered to pay for
...high-pitched loud squealing that increases in pitch as engine revs climb is probably a slipping drive belt. This will happen more often when the engine is cold, and simply requires tightening of the ...
... - Your fellow Biker. tHE CLUNK YOU TALK ABOUT WILL BE BECAUSE THE REVS ARE TOO HIGH, AS FOR THE HIGH REV'S, COULD BE SOMETHING TO DO WITH THE OTHER GUY HAS NOT ADJUSTED THE THROTTLE MECHANISM ...
...high and revs even though I'm in park. Sometimes it will even out when I've driven for a while. When it doesn't though, I'll be driving and it will rev higher on its own and pull me ...
Question about 1999 300M
...Pressing the the accelerator pedal causes the engine to use more gas and if the fuel filter is partially clogged or cloggeg all together the engine will not start. Even a fully clogged fuel filter ...
...high. It should rev down after a couple minutes to a normal idle speed (650-800 RPM). If it revs up and stays there too long (20-30 seconds), it may shut down because of several things: it cannot see ...
...revs until I apply the brake again. After I purchased the Bluetooth scanner I still get the P2128 code but it has G185 signal too high. Would this be a faulty connector, or wire to my accelerator ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
