...reverse lamps are operated via the DTR ( Digital Transmission Range ) Sensor. This is one the side of the trans ( as flbergeron68 posted ). The Reverse circuit is : Cab Fuse Panel fuse #5 to Light ...
...reverse lights to turn on, that sensor might be bad. or there could be a short in a wire which controls positive or ground for the reverse lights, follow the electrical current all the way from the ...
Question about 2004 F150
The reverse lights the reverse sensors on my 2004 f150 crew cab 4x4 stopped working. I have been researching the problem and have checked the bulbs and fuses. What would make the reverse sensors and ...
Question about 2004 Grand Cherokee
...reverse my fuse for my fuel injectors blows. which is fuse26. it works fine in 2wd just not in 4wd help please thank you it is a 42re trans with a np242 trasfer case After looking over a few dozen ...
...sensor to the PCM tells the PCM reverse has been selected , the PCM then will energize the reverse lamp relay (located in the under hood fuse/relay box) there by turning on the reverse lamps . There ...
Question about 1999 Galant
sensor is probably the root of your problems. Likely the reverse switch wiring is routed through the harness for the sensor. That could also be the reason it goes into limp mode. Change the sensor and
reverse sensor fuse No power to reverse sensors have checked all small fuses they are all Ok. Switch in boot is in the on position. Going to need the factory manuals to follow the trouble charts It ...
Question about 2003 Escape
...reverse sensor system on my 03 Escape not working, what can be the cause? reverse sensor system not working Since the reverse sensors are located, usually, in the rear bumper, there could dirt ...
Question about 2003 Escape
...reverse sensor fuse on the Hyundai IMAX, the owners manual and fuse covers do not state it anywhere. My reverse lights and the sensor suddenly stopped working. Checked the wiring also checked some of ...
Question about 2003 Escape
rss warning comes on when i reverse. recently had a tow bar fitted which included wireing loom for reversing sensors. when reversing with trailer sensors stay on fuses ok. A loom problem perhaps? the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions