resistance, typically in the 10,000 to 13,000 ohm range. To get the actual figures for a specific coil, check the manufacturer's specs. But as a rule of thumb, primary windings range from a few tenths
...coils. Secondary resistance values vary widely, so consult a specifications chart for the engine you are servicing. If a spec chart isn't available, compare secondary readings among all the coils ...
Question about 1992 S-10
...body. replaced ignition module. almost started while cranking once. Am thinking now the pick up coil is defective. Need specs for PU coil resistance. Need specs for fuel pressure. google what you ...
...resistance between the plus and the neg. terminals on the coil. Second, measure between the coil tower (where plug wire connects) and the negative terminal. You have to know the specs for your coil, ...
coils. Primary resistance is typically low-about 1 or 2 ohms. Secondary resistance is typically high-about 7,000 - 12,000 ohms. It is specific for different coils, you would have to see the coil specs
...idling after 10 minutes. Ignition coils resistance to spec. Pick up coil resistance to spec. Carb float height to spec. If you're the guy with all the ER5 questions you need trained help and a
Question about 1993 850
...specs for an 850 volvo coil ie primary and secondary resistance original coil is kapoot it does not work have put on a replacement but not sure of originals resistances Specifications per VADIS 1993 ...
resistance specs on borg warner E 262 coil packs I need to know the resistance specs on borg warner's coil packs for ford 5.4 triton engine. Factory recommends 11k to 13k. Found autozones only have 6k
Question about 1993 850
...specs are for the coil on a 1996 Kawasaki zxi 1100 pwc. From the service manual: Charging coil resistance, brown - brown: 0.7? - 1.1? Exciter coil resistance, purple - red: 348? - 523? Exciter coil ...
Question about 1993 850
...resistance of the coils could be less then 1 ohm to over 5 depending on the system and the secondary resistance from 8000 to more then 11000 ohm. Check the "OFF" switch on the right handlebar, make ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions