Questions & Answers for: reset switch maytag neptune

...reset. Any suggestions? My maytag neptune dryer quit heating, after my wife changed the temp setting on the console from regular, to extra low drying temperature. The heating element reads 10.5 ohms. ...

...THAN TO UNPLUG THE DRYER FOR 5 MINUTES, THEN RECONNECT POWER. ON ANY ELECTRONIC CONTROL, THIS WILL RESET THE CONTROL'S MICROCOMPUTER. IF THAT DOESN'T SOLVE THE PROBLEM, THE TOUCH SWITCH MAY BE

...reset it but it still has the light that says its locked even when both sides are in the unlocked position. The lid lock is on the right side but the switch that senses if the lid is locked is on the ...

...Maytag Neptune dryer suddenly quit working. The light comes on inside, but it won't start. This could be several easy fixes. Check to see if the door switch is working if it is not clicking when ...

...reset pressure switch, it will see water left in the washer. 1.Check for pump/drain restriction. 2.Check pump operation. 3.Check pressure switch for open contacts. 4.Check inputs and outputs at ...

...reset the control panel first to get it running? did you forget to plug the door switch back in? or anything else? oh..it didn't start before...ok. you probably should have replaced the thermal ...

Neptune glass front takes 4 hours or longer to dry clothes. Everything seems to work fine, it does not matter if I set it on wrinkle free or not, it still takes forever to dry one load of clothes make

...get it to reset, and start washing clothes. Check out the door switch to make sure that it closes when you latch the front door. If it does not close the machine will be inoperative - safety

...the machine does not seem to know it. Error on the door lock or the door switch, try and use a switch cleaner, remove and reset the lock or check the harness to the switch click this link: Door ...

...reset switch. Disconnect the power to the Maytag dryer and wait 30 minutes. After 30 minutes, restore power and make a new selection. If the problem persists or the dryer will not operate, disconnect ...