Questions & Answers for: reset codes dodge ram trucks

...& 52. what do these codes mean? It's a 1995 Dodge Ram 2500. 12..Battery was disconnected within the last 50 key-on cycles (Resets after 50) They dont list the others may want to recount the

...battery to reset codes after the above parts were replaced. Hello Welcome to FY I would check your speed sensor located on the rear end this is on top of the housing this will throw that code too. ...

...reset the codes with that!!! If you cycled the key, and came up with only -------- done then you have no stored/active codes. There is no need to reset the computer, but if you still want to, you can ...

...reset a check engine light on a 1999 dodge ram 3500? you can disconnect the baterry for one minute or trake the truck to an advance or autozone and they will reset the light for you. If the light ...

...Dodge Ram 2006. No code for trouble. Have disconnected and reconnected battery. ?how do I reset? Have not checked fuses because all dash lights are working could be a seatbeat buckle wiring problem. ...

do I reset check engine light on 2007 dodge 2500 w/ cummings deisel? The lught can be reset with an OBDII scanner. Most auto parts places like Advance or Autozone will read and clear the code for free

...how do you reset the computer in a 2005 dodge 2500 cummins If you are talking about resetting the codes of the computer, most cars can be done by just disconnecting the battery for about 5

...codes can indicate a problem with the transmission, emissions control system and even the fuel system. To erase the code and get the light to go off, you will need to reset the computer. This will ...

...codes were never deleted or reset but after replacing the o2 sensors the code p0340 popped up which is the crankshaft/camshaft position sensor how do I go about having it relearn without having an ...

...Codes P2305 and P2317 after I replaced coil packs plugs and injectors? 07 Dodge Ram 1500 5.7 I replaced the injectors coil packs and plugs and crank position sensor I found some cut wires at the TIPM ...