Questions & Answers for: reset abs light 2002 grand

...reset the computer, it work for a little bit, even the shifting was better, then the light came back on and the hard shifting came back also. Anyone with the right answer will have saved me tons of ...

...abs light off now the sensor been replaced The lights usually reset themselves, however if it still has not turned off, disconnect your battery and leave it disconnected for at least a minute. If you ...

abs light and trac light. what do u think? sensors maybe... did you try your reset button.these cars have a reset in the fuse box,located between the drivers door and dash after you pop that panel off

...FILTER,MY ABS LIGHT,CHECK INGINE LIGHT AND TRAC OFF LIGHT STAYS ON. TRYED RESET BUTTON ,LIGHTS CAME BACK ON. hi...For this problem you have to check the ECM board. check it out.. thank u.. rate

...abs light and trac light. ive tried the reset button. that did not work. Any other ideas? just finisher an 02 with the same lights it was the lt front wheel sensor. the sensor is part of the wheel ...

...u have to do is make sure all the ABS sensors a plug all the way in if so yo h ave to reset the computer disconect the batery for 10 minutes if that dont work have check at any close brake shop u ...

...ABS and traction warning lights came on,,,I changed the pads and now the warning lights wont go out,, is there a reset to the system? Have to have the vehicle scanned for codes , do the repairs the ...

...ABS or Track lights do not come on Hi! Please remove the positive battery connector and let it sit for atleast 5mins. to reset the system. Sometimes its just a computer program failure. Try to drive ...

...ABS, Check Engine etc)...my gas gauge goes to empty. Eventually they go off....what is causing this? Went to Auto Zone and they said my battery was bad...bought a new battery and it is still doing ...

...abs and traction light came on I needed brakes so i change the brakes the lights sayed on how do i reset them. need the scantool for erase the light and check if the problem is solved or need another ...