Question about Office Equipment & Supplies
...reseat the dimms. But the Rom Dimm is usually bad and needs to be replaced. A 020 error is the TNY on the controller board. If you take the controller board out (it's the board that the usb/network ...
...board to me. Make sure that the DIMM expansion is clipped firmly in and home, and then try again. Then try removing it completely and see whether the printer still crashes. If the printer works ...
...dimm or application boards read errors try taking the memory out and the app board out and reseat them again.. then go into the service mode via yellow clear button and then enter 107 then hold down ...
...reseat" the DIMM modules. Try removing and the memory and putting them back. If that doesn't work, the next solution would be to take the memory modules to a reputable computer repair center and have ...
...reseat the formatter board, power on and test. Check firmware version: on newer machines with flashable firmware upgrade to the latest version. If you are running the latest version reload it, this ...
Question about OptiPlex 330 Desktop Desktop Computer
...DIMM or defective system board 1-3-2 No memory installed No memory installed or faulty or improperly seated DIMM 1-3-3 Chip or data line failure in the first 64 KB of main memory Faulty or improperly ...
...Reseat the DIMMs in the memory slots on the system board, then power on the system. DONE, got the same 5 blinks. 2 Replace the DIMMs one at a time to isolate the faulty module. DONE, they work both ...
...to update the firmware), the product will no longer function. In this case, a firmware recovery DIMM is available. Reseat DIMM, then Formatter - Replace or flash DIMM then formatter Can this also
Question about Laserjet M2727nf Multifunction Printer
...Reseat or replace memory in DIMM Slot J3. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-bpl11648 If the message persists, contact HP Support Center for further assistance from the ...
Question about Laserjet M2727nf Multifunction Printer
...PRINTER WILL NOT WORK AT ALL. I TOOK OUT (RESEATED) THE DIMMS AND THEN LEFT PRINTER UNPLUGGED ALL NIGHT, AND I STILL GET THE SAME ERROR CODE 62.0. it is either the formatter board or the dimm ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions