Question about Tools & Hardware - Others
...piston no longer returns all the way to the top, thus blocking the next nail from entering the firing chamber. Lubricating and replacing all o-rings did not help. No obvious signs of wear, dirt, or ...
I cannot remove the old cylinder sleeve to get the new one in. What do I do? on what unit are we trying to remove the cylinder sleeve?could be rusted in place are welded from lack of lubrication. may ...
Question about 907068 MILLER TRAILBLAZER PRO 350D KUBOTA DH905
on kubota v2203 i drilled thru a frost plug while installing block heater and accidently drilled thru piston sleeve. what can be done to fix? replace the sleeve if they are removable if not find a ...
broken piston Have craftsman upright air compressor.A year ago the piston broke causing damage to the housing. I replaced piston and sleeve. I fired it up today hearing odd noise. The same piston was ...
what is the case surrounding the piston Its called the bore.Some have them cast with the engine block.Some have a sleeve that is put in after the casting.this one is sometimes removable and may be ...
...replacing the piston rings? are you using a spring compressor? when you compress the rings and set the piston down in there sleeves make sure to oil the cylinders the with the rings compressed and ...
88 honda cr 250 I am concidering either sleeving or having the cylinders in my engine refurbished, I would like to know which would be the better choice and what piston should i got with. How to tell ...
...SLEEVES? BOB Bummer. Usually you need to drop the oil pan, pull the rod and piston out, replace the sleeve, and use a ring comprssor to get the piston back into the cylinder and then put it all back ...
...PISTON INTO THE CYLINDER SLEEVE WHEN REMOVING THE HEADS FROM THE BLOCK TWO CAST IRON CYLINDER SLEEVES CAME OUT WITH HEADS. THERE IS LITTLE TO NO ROOM TO BE ABLE TO COMPRESS THE RINGS AND SLIP THE ...
Question about 2000 Camry
...seals blowing past. will this cause sump compression. have had the sleeves and pistons replaced. yet still blows smoke from breather pipe. It's your piston rings not sealing properly in the piston ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions