Imaging Unit: 46% Fuser: 52% I've contacted XEROX and they didn't help. I also called a Xerox Service Provider and they said that the "laser might be dirty" and they will come and look at it for $200.
...Imaging Unit The Imaging Unit was just replaced on this printer. the message will not clear. There is a spring on the waste section of the imaging unit that often pops off. When that happens it will ...
Question about Phaser 7750GX Laser Printer
Imaging Unit Percentage Question? I replaced 3 imaging units today on my Xerox Phaser 7750 and they do not read on my Supplies Usage page as 100%? One reads at 46%, one reads at 28% and the other at 9
...xerox.com -phaser 7400- support -fault code-941 says cyan or magenta toner failure, but the solution says to 1. remove & reinsert the cyan or magenta imaging units. 2. replace imaging units . ...
Question about Phaser 7760DN Laser Printer
...imaging unit" Xerox phaser 7760 saying "non-phaser imaging unit" for the same imaging unit that was working before, pls help. There is a snippet on the Xerox website to solve imaging unit ...
...imaging unit stuck I have a 6360 xerox phaser and the imaging unit needs replacing. It is stuck and will not come out. Any suggestions? The lid lifts a lever on the right side of the printer that ...
Question about Phaser 3100MFP/S Laser Printer
How to reset toner chip on Xerox Phaser 6121 mfp printer? You would have to replace the chip, there is no reset for it. Plus you would need to refill the cartridge with more toner as well.
xerox 6121 mfp jam at fuser if it's in warranty engineer. Otherwise check at the back if there's any paper in the fuser, or a sensor in the wrong position. (Fuser get's warm.. for recognition)
Question about MAGENTA IMAGING UNIT, PHASER 6700
How do I replace the imaging unit on a 6700 Xerox phaser How to change out replace If you are not a technician, don't try to do it yourself. Take it to a repair shop.
Question about MAGENTA IMAGING UNIT, PHASER 6700
How to fix fuse failure code 0500 phaser 6121 Xerox 0500 is a fuser failure error. Need to replace fuser. http://www.iteminconline.com/126e02770_126e02770-xerox-6121mfp-fuser-110v-new.htm
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions