Questions & Answers for: replaced ink printer cannon pixma

...Ink U130 5BK. I try to press any buton, ok button, but nothing happens. Seems that is locked. Pls help me. replace with a original cannon new cartridge and try again Hold down the Stop/Reset button ...

...printer will report no ink at all, these cansometimes be cleaned by soaking them in acholol I WAS TOLD THAT A DOCUMENT COULD BE RESTRICTED TO PRINT IN BLACK. THEREFORE WHEN A COLOR CARTRIDGE IS LOW I ...

cannon mx310 will not recognize cartridge I still keep getting error messages when I replace cartridges, error 50. I have tried to reset to no avail, it just runs the paper through and says th ink is ...

...them and get refilled? techidiot I suggest that you go to the Cannon site and look for the manual for your printer. It should provide all the information that you need to replace the ink

ink getting low should i replace both color and black how can I tell?I have a CANNON pixma IP1600 It should tell you either "replace colour", or "replace black". You only need to replace the cartridge

...Cannon original ink and a low cost version. Anyone have any ideas? It's probably a blocked jet in the print head but could also be a page registration issue. Try gently wiping the print head with a ...

...replaced the printer head on this after trying to clean it by running water through it. Since then I have only had to do the maintenance cleaning when the printer "skips". I bought an "R-JetTek" ...

...ink is low on both Hello! After you installed the new cartridge, just press and hold the stop/reset button for at least 5 seconds. The printer will restart then. Do it twice if both cartridge have ...

...replaced them with 3rd party ink cartridges from a reputable source. I first replaced the yellow, then the red, then the blue, about a day in between for each. Everyting worked fine until I replaced ...

...ink cartridges into its corresponding slots, and then check if the issue persists. If yes, then turn Off the printer again. Check the printhead and replace it, if necessary. Failed or overheated ...