Questions & Answers for: replaced cats o2 sensors drive

O2 sensor problem. Had catalytic converter replaced under recall, did not even get to drive it off dealer lot when check engine light came on. Dealer will not fix under recall. Thinks oxygen sensor is

...replaced in the past 3 weeks both front axles (drivers side twice, outer tie rod end driver side. had an allignment. both front shocks. and a idle air conrtol sensor. oh and my o2 sensor in my cat is ...

O2 code p0152 how repair replaced the sensors [4] O2 code p0152 how repair replaced the sensors [4] and erased the code The O2 sensor is located on the exhausts manifold, or/and on the cat. Converter.

...o2 sensors but the check engine light would, the cat problem may be a bad cat, these jeeps are famous for cats, if you replace the cat i would also replace the 02 sensors. the abs problem on these is ...

...replaced the top O2 sensor and she runs nicely now, I expect fuel economy to return.  You can clean sensors sometimes (no water), but usually its corroded so just replace it. $70 for a sensor is ...

...replaced front 02 sensor, right before the cat. the sensor before the cat is NOT an O2 sensor but a HO2S sensor ( two different sensors with different operations). If this is a V6 engine there are 4 ...

...o2 sensor 0n a 6 cylinder jeep grand Cherokee laredo locations bank one is left side top of engine standing looking at it , O2 sensor is located on exhaust manifold there is one on each manifold ...

...drive European markets only began to officially receive them (in RHD form) in 1993. Models were offered in both markets until the XJ's discontinuation in 2001, at which point it was replaced by the ...

...o2 sensor in my 99 Jeep Grand Cherokee, which after the fact I saw it was I fed emissions Jeep. Would I still c signs of bad o2 sensor The post-cat O2 (emissions) sensor reports the exhaust gas ...

drive shaft. My cat has no wires going into the cat nor are there any wires hanging that might have at one time wired into the cat. Easy thing first- check for a fuse for the O2 sensor heater circuit.