Questions & Answers for: replace valve cover gasket 2004

Question about 2000 LeSabre

1 Answer

...There are two small bolts holding the PCV cover. Often there is a fairly large vacuum line coming into the enclosure. Remove the cover and pull the PCV valve that sits down into a gasket. ...

Ad

Question about 2000 LeSabre

1 Answer

...replace the PCV valve on a 2000 Buick LeSabre. But I can't find it. Can some please send me pics Open hood, top left side between the valve covers. There is a "funky" plastic housing that turns ...

Ad

...valve cover gaskets were new... still smokes and is now knocking. was told it is a blown head gasket. if i replace the head gasket and the oil pump, will i need a new motor? would ththat solve the ...

...valve cover gaskets are getting old and cracked. They should be replaced as it will only get worse. It's an easy fix, just pay attention to what you unhook and where it came from so you can get the ...

Question about 1993 LeSabre

1 Answer

need to change out valve cover gaskets need to know torque settings I personally don't think a valve cover, falls under the need for a torque wrench,unless it is a millon dollar formula 1 race car

...located on a 1985 buick lesabre. Engine 307. on the valve cover gasket it has a small skinny hose coming from it your oil fill hole is on one side and the pcv is on the other side In the valve ...

...2004 Buick Lesabre heater doesn't heat up I don't seem to be getting much heat from my heater. What should I check? Thanks. First you should check your antifreez level , check your water ...

Question about 2000 LeSabre

1 Answer

...valve cover gasket off to replace the gasket? You'll have to remove the brackets on the back side of the intake manifold to access the valve cover. Most likely you'll have to remove the spark plug ...

REPLACE VALVE COVER GASKET ON 2004 BUICK LESABRE NO COMPRESSION ON #6 Replacing valve cover gasket is not going to fix your problem. No compression means you have a problem with valves, lifters or ...

valve cover gaskets? Valve covers usually don't have a torque spec. Just snug the bolts up and then give it about a quarter turn. Valve covers torque in inch pounds to keep from warping the flange . I

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...