Questions & Answers for: replace speedo needle

...speedo cable or do ineed to change whole dashboard. if someone can help me i`d be greatful.thank you Your spedo needle could be bent. I noticed that many of the dial needles are bent from the heat. ...

...speedo needle was behind stop pin at 0. put needle back over to right side of pin. took car for drive everything woked fine.turned car off. started car up again and went for drive, speedometer and ...

...now has completely stopped working. It sounds like the cable was kinked, which was causing the needle to jump. Now the cable has broken, so the speedo won't work at all. Replace the speedo

...speed senosor what do i do next? you are going to need to replace the speedo head or have it repaired, the little motor that operates the speedo needle is defective, it is called the "Stepper

I have a 1984 s10 durango and the speedo needle does not go to the mph your doing . Just goes completely around. Thanks The bushing in the speedo head is worn.Replace the speedo

...sure they are attached properly. If so and still not fixed I imagine a new cable is cheaper than a new speedo so I would start there first. and lastly if still not working replace the

...was correct. (if wrong here , ask) that means the speedo is bad. (if pcm sends right speed to speedo head and speedo head is wrong ,its is bad. replace it) but do check all fuses, just in

...Speedo needle stays at zero or erratically and violently swings between 60 & 80 after the car has accelerated from 0 to 70. After the car stops, the needle returns to 0 but quickly jumps to 40 for an ...

...REPLACE SPEEDO FACE How to remove the speedo face Undo the 4 screws that hold the black cover in front of the speedo. Pull the cover off. Undo the 4 screws that hold the instrument cluster. Lift out ...

...replace the entire dial unit, (speedo, rev counter, fuel/temperature gauge), as one piece There is also a drive gear in the transmission transfer box that the cable bolt directly into. These can wear ...