...toyota and a couple thousand miles later they began to chatter. I heard that a whole new brake system is the only solution. Chatter is caused by brake pad vibration, they make a paste that you put on ...
...replace brake pads & rotors how do you replace the brake pads & rotors on a 2007 toyota tundra crewmax. The dealer says here a "special" wrenches required, and the larger pads and rotors are not ...
2007 tundra brake pad replacement FRT OR REAR.. IF DISC. REMOVE CALIPER BOLTS. EMOVE CALIPER REEPLACE PADS. MAKE SURE YOU USE BRAKE QUITE BEFORE INSTALLING PADS.. PREVENTS PAD NOISE
Question about 2003 Tundra
...month you must replace the rotors they are too thin and the heat is warping them faster then before youhad them turned note you replace brake pads and rotors good luck
Question about 2007 Tundra
pads and there is a grinding noise Here is what I have found out. I have an 2008 Toyota Tundra 5.7 4x4, and I changed the rear brakes and rotors. No noise prior to service. After installing new rotors
replace-parking-turn-and-brake.html----------Squeak and grinding sound is heard when brakes are applied? http://technoanswers.blogspot.in/2012/02/squeak-and-grinding-sound-is-heard-when.html----------
Toyota Tundra shimmies when braking. Just raplaced rotors and pads and didn't fix problem. Who is doing the work on your truck ?Did they put in the problem or neverwere asked to resolve it?You
...replace a front rotor on a Toyota Tundra how ever this is for a older model of tundra. With my knowledge of working on cars and trucks the same process usually applys to almost all vehicles for rotor ...
Question about 2002 Tundra
...replace a front rotor on a Toyota Tundra how ever this is for a older model of tundra.With my knowledge of working on cars and trucks the same process usually applys to almost all vehicles for rotor ...
Question about 2007 Highlander Hybrid
...pads ok but the rotor not so much. What tool and size tool do I need? I have a 1/2" impact wrench. The rotors are knock off rotors. They are just rusted and stuck to the hub. DO NOT REMOVE THE AXLE ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions