Questions & Answers for: replace right cv joint dodge

...replace the half shaft. You can check the CV Joint. turn the wheel all the way to the left and drive in a circle and then go to the right and see if there is any diffence in the noise and see if it's ...

...cv joint about to fall out.To repair this ,the whole axle will have to be replaced.Axle is about 59.00 at NAPA auto parts.But do check the play in the wheeel,jack the car up one one side in the front ...

...CV joints in axle assemblies. Good luck with this! I have a 2006 Chrysler van.T & C. When I travel over a rough road I hear a VERY load clunking from the front right corner of the van. Any one ...

...replace and i hear scrubing,clunking. and popping. when come to a stop or taking off. the popping can heard and felt on passerger floor board I think you mean of the CV joints were replaced, right ? ...

right. Half shaft or CV joint? I'd say constant velocity joint. It's been my experience that the offending side is usually opposite from the direction being turned. Turn the wheel to each extreme side

CV joints, all motor/trans mounts, & tires. There is still some creaking from the front end when I take off from a stop. I believe this is the stabilizer bar links. Also, the boots are cracked and

...i make a left oor right turn with the stering wheel the car makes a grinding noise it indicates that the cv joint of ur car is worn out. u can get them repaired or replaced according to the

right rear, left front just like the manual said. Now the brake pedal is hard when the car is not running, but spongy when the car is running. I am thinking I may have a bad master cylinder, but would

...Right I dont hear it its when I drive straight that i hear it. I took it to a pro mechanic shop they said it was the lower driver control arm that needed to be replaced and that the CV joints and the ...

...cv shaft failure. It makes the same sound whether I turn right or left. I drove it a few times and the sound seems to get progressively louder. There is no sound when not turning unless I hit a bump ...