...replace the push,pull throttle cables on my 1998 1500 suzuki intruder, any help? Jim It's not too hard of a job. loosen your throttle cable ajustments first. you may find it easier to remove or slide ...
Question about Bilt 5.5hp Self Propelled Mower
...forward and hold it while pulling the cord. Is there a way to adjust the cable or does it need replacement? just tighten the adjustment screw after you push the throttle all the way down...good ...
...push against the throttle switch assembly. Check the cables move freely Check the cables dont have any frayed ends check the cables arnt missing any of the plastic outer cover check the cables a ...
...replace yourself. You will have to get the new one from the dealer or a scrap yard. It would be held on by a few push on clips and or small bolts/ screws. Start by unhooking it from the pedal and ...
Question about 1997 Cutlass
replace? My Victa push lawn mower won't shut off. Throttle cable pulls back but won't push forward and springs underneath housing seem extremely loose. What do I need to repair/replace
push mower an the throttle cable is broke from handle an its fires up but idels very high until I pull the cable then it runs almost how I did this? Take model no. of mower to mower repair shop to get
Question about 1997 Cutlass
...replace just the cable. After the handle and cable is replaced..push it to the open throttle and then push the linkage to the full throttle position and tighten the clamp...you can make further fine ...
...Harley Davidson dyna. Can I correct without replacing the cable? problem usually is throttle pipe has been pushed into handlebar remedy is just undo switch and pull back slightly till throttle is ...
Question about 2006 FXDI Dyna Super Glide
...replace the control cables if frayed, kinked or bent, put one or two drops of oil into the housing of each control cable. INSTALLATION Apply a light coating of graphite to the handlebar and to the ...
Question about 2006 FXDI Dyna Super Glide
replace the throttle cable on a 1991 Ford E250 Club wagon van with a 7.3 Diesel engine It is on the gas pedal rod and goes through the floor to the throttle body pull the engine cover and then look at
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions