Questions & Answers for: replace lower ball joint dodge

...lower ball joints I need upper and lower ball joints replaced on a 2004 Dodge Ram 1500 4X4 extended cab. Can I perform this repair myself an if so How. Your better off have it done bt a tech because ...

REPLACE UPPER AND LOWER BALL JOINTS just tare the axels down and pull the brake callipers and brake disks, to get to the ball joints. un bolt the nuts and take the peice holding the ball joints in and

...lower ball joints on a 2005 1500 4x4 ram It is also possible to buy the complete lower control arm, but again, just as the last guy stated, it does have to be aligned, You may want to get the ball ...

...replace the upper and lower ball joints.  I am aware and have the press needed to replace the joints on the control arms. to remove the axles, remove brake caliper and disc, remove hub assembly, ...

...lower ball joints are located i dont know where my ball joints are located on my dodge ram 1500 4x4 extended cab truck If you turn the steering one way fully, looking behind the front wheel, you will ...

...replace ball joints on 1997 dodge ram 1500 jack up truck support truck remove brake caliper and support the caliper dont let it hang by the hose remove cotter pin from bottom of ball joint remove ...

...lower ball joints. I was able to do the passenger side fine but am having trouble removing the axle from the spindle on the driver's side so I am unable to remove the spindle to press out the lower ...

...lower ball joint on my 1999 dodge ram 1500 4x4 You can got to a parts store and they will loan you a ball joint tool, all it is is a wedge type fork, that you beat the heck out of to pop the ball ...

...lower ball joint cant get enough room between cv joint and spindle to get ball joint stud out remove the axle nut and pull the axle off of the hub. Now you should have enough room to get the ball ...

...replace both upper U-joints, Both outer tie rods and both lower ball joints on a 2002 Dodge Ram 1500. The truck is a 2002 Dodge Ram 1500 with a 4.7 engine. I am just interested in the book hours not ...