COLORADO RANDOM MISFIRE ON #3 CYLINDER IVE REPLACED OVER THE TOP COIL AND SPARK PLUG AND RE HOOKED BACK TO MY MODIS AND ITS STILL SHOWING MIS FIRES.#2 AND #4 ARE ALSO SHOWING A SMALL AMOUNT BUT NOT AS
I replace f injector, all spark plugs and I swap I replace f injector, all spark plugs and I swap two coils. I still get an error misfire number 5 Check the connector on that cylinder,if it is ok,then
Question about 2006 Colorado Extended
I have a 2006 Chevy Colorado..Check engine light on and code 171 came up. Oxygen sensor replaced as was gas cap..Still on..What else needs repairing to fix this?? short term fuel trim bank 1 ...
2006 chev colorado Oxygen sensor burns out I've replaced 3 times. This time it lasted one week. The last one lasted one as well. When pulled out it looked burned. Rich smelling exhaust, will ...
1998 chevy k2500 We think the catalytic converters need replacing as there was a strong smell of rotten eggs. Further issue is the truck is idling very rough. We think one fuel injector is not working
Question about 2006 Colorado
...Colorado 2.8 engine. The motor surges slightly under normal acceleration but smooth out under hard acceleration. Gas mileage is normal. I change the plugs which looked good. No trouble codes detected ...
replace fuel injectors in 2005 Chevy Colorado? remove the bolts that hold the fuel rail. Lift the fuel rail, pulling the injectors out carefully. Make sure the rubber seal comes out with the injector.
Question about 2006 Colorado
injectors on my chevy aveo 2006 and it still had misfire codes on cylinder 2 and 3. what could it be? My check engine light burned out so I have to replace it. the car runs great and does not have any
Question about 2006 Colorado
...colorado 2.8 liter no start changed cam and crank sensor fuel injectors chek ok and power coming to them will crank on starting fluid What is the fuel pressure reading? Injectors check OK? Ohms, ...
Question about 2006 Colorado
...Colorado had to trailer it home. Wouldn't shift out of second gear (auto) so I replaced the shift modules in the trans. Now it cuts out around 3200 rpms so I replaced the crank sensor you can let off ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions