Questions & Answers for: replace ignition switch 1988 olds

...It has been too nice out not to be able to drive this car! sounds to me like the ignition switch did you also replace the starter solenoid did you connect the wires to the starter solenoid ...

...ignition switch will not turn to shut the car off. I suspect the ignition switch went back and needs to be replaced. I am looking for a procedure to remove the old ignition switch. Thank you in ...

...ignition switch. You should have a starter solenoid on the fender apron. The small wire(s) that go to it make the connection from the ignition switch and cause the spark to jump from the main battery ...

...SWITCH IGNITION WIRING HARNESS TOOK HOME WOULD NOT FIRE IN HOME DRIVE THE GARAGE SENT FOR IT. CRANKED DID NOT CRANK CRANKED -- DID NOT CRANK - CRANKED DROVE 12 MILES HOME NEXT DAY WOULD NOT FIRE BUT ...

...replace anything unless there is power in but no power out. You have not used a test light to verify where there is power yet. You need to check every single connection in the chain. Start with the ...

ignition switch is hung in the start position, that would keep the starter spinning even after you release the switch. I would consider replacing the ignition switch. Look over on youtube for a how-to

ignition switch, all belts and vacume lines, and converted ignition to hei. Problem is i have no power to dash and when i try to turn it over i get nothing, also when i put the key in the ignition the

...replace the ignition key cylinder. How do you remove the old cylinder & install a new one ? take the sterring wheel off get this horse shoe looking tool to press the in plate take the snap ring ...

replace the washers in a brand new ignition switch to match your existing keys. Removing the lock cylinder could be a bit of a problem if you can't wiggle the ignition switch at all. However, don&

...coming from the battery area. What is going on? Probly blew startr motor or whats left of original. Ignition or key switch cud b old tu. Pound on startr w a hammer to see if it comes back. Then ...