...HEADLIGHT.... i think my suggestion will work for u.. well first locate the horn it will most of the time be on the front end next to the radiator on the driver side is where they put them check the ...
...headlight switch is no good unscrew the area above the stering wheel and take out the dash. you will have to disconnect the shift wire and look on the back of the dash. there should be about 6 bulb ...
...headlight casings to replace bulbs or whole casings, i also cant open my driverside door and dont know how to get the mouldings from interior off to see whats happened thanks debbie Check that ...
...headlight relay. With the low beam on, test for voltage at that wire. The other option is to switch the bulb out with the other side and see if it works. If it does, then it's just the bulb. If not, ...
...headlight will have to be on to test this,if there is no voltage going to the fuse(remember to adjust the dimmer when testing also)replace the head light switch,this circuit is controlled by the head ...
...headlight behind the front bumper. you will need to remove the splash shield to get to them. Hope this helps you The horn is located under the hood but it is unlikley it is the horn. Check the horn ...
...headlight switch but check the relay first. The relay is in the dash as shown in the picture below from your owner's manual. With the battery connected, pull out the relay and push it back in. If the ...
Question about 1996 Explorer
...headlight drivers side don`t work. high beam it works. high beam, drivers side works , don`t work on low beam Check tour bulbs first and replace if blown. If OK then check wiring backwards from light ...
1996 ford explorer eddie bauer 4x4 Headlights only work on high beams and not low beams replaced bulbs same results any ideas? Dimmer switch more then likely (hi ,low switch) , but testing B+ voltage ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions