Questions & Answers for: Oster replace fuse Televison & Video

Ad

Question about 4134 / 4126 Classic Beehive Work Top Blender

6 Answers

replace the fuse on my Oster Blender? After a brief spark from plugging in my Oster beehive blender, It stopped working. Because there was no smell, I assumed the motor did not burn out and perhaps it

Ad

Question about 6854 14 Speed Blender

1 Answer

...not, you can try to replace it. Most times, the fuse is attached with crimp-on connectors. Replacements can be soldered in, if you put a clip-on heat sink between the fuse body and the soldering

Ad

Question about 6804 16 Speed Blender

2 Answers

number I've been able to find is 5S5A125V. Can anyone recommend a common (Littlefuse, Buss, Cooper) replacement? Duane I found the answer with a bit more research on the Internet. The replacement fuse

Question about 12-Bottle Wine Cellar - Black

28 Answers

...fuse (part # 270-1066). Now the wine Refir works great! To replace the part take all the screws off the sheet metal covering on the back of the refrigerator. Remove the circuit board from the plastic ...

Question about 12-Bottle Wine Cellar - Black

1 Answer

...a replacement fuse - how do I get into that black covering and replace it? If you don't mind, step-by-step instructions would be greatly appreciated.. thank you! Lisa how do you replace the

Question about 12-Bottle Wine Cellar - Black

1 Answer

...fuse. they say it is critical to get the right one. Anyone know which it is? Thanks K I just replaced mine with a "Slo Blow" and it is working just fine. Got it at Radio Shack , 4 for ...

...fuse and run wires from original holes to fuse holder. Both units now working. If fuse blows, now all I have to due is screw off fuse cover and replace fuse. Total cost for two units about 7 ...

Question about 12-Bottle Wine Cellar - Black

1 Answer

...fuse you need to replace is probably the one in a black shrink rap on top left side of the panel. You will need to cut shrink rap off fuse and find wires. Next step cut and solder in new fuse. I ...

Question about 4093-8 Osterizer Classic Blender 2-Speed Blender

1 Answer

...REPLACE FUSE? unplug it.... use a small plastic screw driver or even a metal one if you are careful... pry gently up on one side of the fuse... it should pop out of the holder. when it does... use ...

Question about OGB61101 Microwave Oven

1 Answer

...control board is, now look down where the printed circuit board is, fuse should be near by clipped in, pop fuse and replace with same current rating, assemble before testing, "lethal voltages

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...