...the front nd during braking, although all brake pads/disks have recently been checked clunking noise could be a wheel bearing. in some cases a bad bearing can take out the abs or wheel speed ...
...front disc brakes have 2 little pins holding the pads in. I am not sure how to take these pins out so i can trade out the pads. It is fairly easy. On these cars, you don't need to unbolt the caliper, ...
...mazda 323 m reg fluid leaking from rear wheel, what could it be? Sounds like you have a leak in the brake system. The fluid you are seeing is brake fluid. You need to get this fixed asap. sounds like ...
...replace my front pads there are 2 I'm trying to replace my front pads on a 1989 mazda 323 there are 2 long pins that go inside the end of the pads. that hold them in place, i can not get them out is ...
...front brake pads on a 1998 mazda 323 Well, get the car up, take the tire off, Take a C clamp the bigger the better since it has ABS. Lock the C clamp on the hammers and tighten. Actually here is my ...
mazda 323?? I've done a thousand brake jobs, This one has me STUCK!! Did you ever get an answer or a solution to your problem for the 323 brake drums? I am having a similar problem with a 1990 323 and
how to change the front brake pad on a my mazda 323 bf Please see my tip at http://www.fixya.com/cars/r6016398-replacing_brake_pads_shoes and let me know if you have questions.
front or rear, disc or drum brake. If disc, remove the brake caliper, and then remove the brake rotor. This is all the disassembly that is usually required to replace a wheel stud. Once completed. you
Question about Brakes for Mazda 323 4-Door
mazda 323 1999 hand brake adjusting near brake asembly adjustment near rear brake asembly what way do i turn the adjustment towards rear or towards front Here's a link to your brake adjustment.
Question about Brakes for Mazda 323 4-Door
...replace rear wheel bearings of a Mazda 323, 1.3,sting,front wheel power Mazda 323,sting, 1.3 engine capacity,front wheel power take the rear hub off you will need a hydraulic press or a vice to push ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions