...door hinge are worn. Is there a trick or special tool for compressing the spring on upper hinge to get the pin out? I USE A PRY BAR TO GET THEM OUT. GETTING THE SPRING BACK IN DOES CALL FOR A SPRING ...
door spring fellout whats the part called that the spring pushes on that is part of the door hinge.
GMC Jimmy and my car doors are not closing right. I have to lift upon the doors to get them to close Sounds like the pins and bushings on the door hinges are worn. This could be a project that you can
...door hinge spring mechanism is broken 97 gmc jimmy The spring is likely "broken" because the pins in the bushings are worn. It's a common failure point on many GM vehicles. The hinge pins, bushings ...
...replace). thanks the door problem sounds like the door pins and bushings are worn out. this should be fixed asap because if it is let go the pin will cut into the hinge itself and then they may also ...
door hinge has removeable pins and bushings replace them, otherwise replace hinge. Also you might jimmy it by loosening latch pin and move it upward and retighten. several attempts may have to be done
...door and support it from the bottom, and then go for it, one pin at a time - for the upper pin, compress and remove the small spring, drive out the old pin, drive in the new pin and put the spring ...
...hinge pin holes ablong on my gmc jimmy? the doors are heavy and from wear and tear the circular holes become oblong. you can purchase a replacement set of door pins and bushings from autozone to ...
Question about 2000 Jimmy
...replace the hinge pin and bushing kit,on the drivers side door on a 1999 Jimmy 4.3 1994 to 2003 Chevy 10 GMC 15 Blazer and Jimmy Door Hinge Pin Replacement this should help you I think is the right ...
Question about 2000 Jimmy
how do I adjust my driver door on my 2000 gmc jimmy, I have to lift it up to shut it Sounds like you have to replace the hinges.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions