replace your camshaft position sensor and crankshaft position sensor at the same time. The parts around $60 bucks together. The camshaft senors sets on the side of the engine and the crankshaft sensor
Question about 2001 PT Cruiser
...crankshaft pulley 2001 PT Cruiser... How too remove crankshaft pulley 2001 pt Cruiser GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU ...
...Replace the rear oil seal housing if the specified measurement can not be reached. Install the flywheel. Install the oil pan. Fill the engine oil and the cooling system. Check for leaks 5.3L EngineTo ...
crankshaft position sensor replacement 2005 pt cruiser it helps if you can lift or jack up the vehicle. be sure & use jack stands. it should be above oil filter on engine block under exhaust ...
...crankshaft rear oil seal replacement is the only operation being performed, it can be done in the vehicle as detailed in the following procedure. If the oil seal is being replaced in conjunction with ...
...try start the engine when the oil light turn on, it would harm your piston, camshaft and crankshaft It should be the oil pump has broken and need to replace, tow your car to the nearest service ...
...oil filter as on 01-03 PT's. REMOVAL - 2.0, 2.4, 2.4L TURBO The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION). ...
replace the rear seal on a cadillac cts YOU NEED TO REMOVE FLYWHEEL REMOVE OIL PAN. REMOVE REAR OIL SEAL HOUSING BOLTS. USING THE PRY POINT LOCATED AT THE EDGE OF THE CRANKSHAFT REAR MAIN SEAL HOUSING
to hold crank shaft in place to stop moving seal out is that correct. Thanks YOU CRANKSHAFT FRONT OIL SEAL IS LOCATED IN THE TIMING COVER WHERE CRANKSHAFT STICK OUT.THATS WHERE OIL LEAK IS MORE LIKELY
Question about 2007 PT Cruiser Touring Hatchback
is the same for all pt's except for the Turbo one, if you have a crankshaft sensor issues will recommend you to replace the harness, those tend to go bad due to the constant heat and oil going to this
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions