...crank shaft positon senson on a 2003 hyundai sonata with a 2.4 engin the 2.4 i believe the sensor is under the front plastic cover that hides the belts at the bottom of the engine, if it is i wouldnt ...
...crank angle sensor. it needed replacing at NZD180.00 with 3 hours labour to do it. evidently they remove the front of the engine and cam belt etc. the workshop at Hyundai did it and charged 3 hours, ...
Cold engine is hard to start. Takes several seconds of cranking before engine starts. replace your water temperature sensor!
...crank position sensor and sensor blade (tone wheel). Also, the front balance shaft (on the side of the engine nearest the radiator), has THREE different positions when the timing mark is lined up - ...
...replace it? Hi there, here are a few tips on how to go about the replacement: To begin, Jack up the driver's side of the Sonata and slide the jack stands under the frame. Set the car down on the ...
...crank sensor, coil pack, plugs, wires,fuel injector,fuel pump,cleaned maf sensor. HELP!! Pulled plug...it's black and wet. You did everything you can when its wet and you replaced plugs coil ...
...crank positioner sensor and still wont start, anyone know what could be wrong? Firstly stop changing pieces willy nilly as it costs money and is unnecessary ,firstly go back to basics and remove a ...
...crank shaft clockwise to set the timing marks. Intake cam, exhaust cam, left balance shaft, right balance shaft/oil pump, and crankshaft sensing blade. 5 sets of timing marks in total.14.Use a ...
replace a 2003 Sonata Crankshaft sensor the check engine light came on and was diagnosed as the Crank Shaft Sensor is going bad. Is this something that can be done by me. It can be but it is a bear to
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions