...replace starters and alternators when the problem was in your connection... also some places test alternator for free i would venture to say that you have no spark. have the ignition system checked ...
...CRANK position, and then to the RUN position. The vehicle will start and then stall. Leave the ignition ON until the security telltale turns OFF in 10 minutes. Repeat Steps 3-5 for 2 more times (3 ...
...crank shaft position sensor. Had sensor changed be still have problem. New battery start checked OK. also have secondary air pump code but was told that would not cause problem? help sounds like the ...
position sensor or possibly the anto-theft system. Is the secuiity light on? Is the engine light staying on? Please check fuses 5 and 10. See diagram below. Thefuel pressure is suppose to be around 60
...crank sensor, and timing chain. Once i did that it ran great for a week with a little puttering when i turned it on then one day after it had been off for a full day i went to start it and it just ...
...Crank position sensor sending bad signals. If you hadn't said you replaced the cap and distributor already I would point you to checking the inside of the cap to see if someone took a pencil to ...
Question about 1995 Blazer
...crank position sensor,still no fire,and no codes it used to fire after a day or 2...then i replaced these parts to try and stop it from happening again...no such luck...no fire and no codes...hard ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions