...board (Controller), but at $260 for a new one plus labor, ouch! Just had a new front door seal done on this thing 3 months ago, and just that simple operation put me back about $250 from the Bosch ...
Question about Nexxt Premium WFMC6400UC Front Load Washer
I need replace the control board, but I can't find where purchase it. RepairClinic.com (which is good) espares.co.uk AppliancePartsPros.com You can rate me........
replace the Control unit. aka(motor control unit). In you washer, they call the motor control board a (Control Unit). replace this asap if possible. this will fix your washer. ADDITIONAL CHECKS--(Make
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
...control board on frt. worked for 2wks. then problem returned. got another board. now will run for 1 complete cycle then does what it wants again. any suggestions. checked incoming current. all fine. ...
...board is faulty. If water fills and stops, then the there must be voltage to the motor , check with a meter to the motor, if motor hums or is hot, thenit is possible that the capacitor is faulty. ...
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
...usually will cure your problem sometimes the washing powder or fluid dose nt clear away properly leaving the hole blocked preventing the control board from activating the wash cycle here's hoping ...
...control board, but they are $300+ and I'd probably replace the machine instead. Any suggestions? Hi wwwylie, First check the Drain Pump filter, as the last 2 cycles of a machine is Drain & ...
Question about Nexxt 300 Series WFMC2201UC
control board has just started to fail and it will need to be ordered and replaced to fix the issue. If you pull the washer out and remove the back panel, there is a control board mounted to the floor
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
replace the motor control board on my own & where is the best place to purchase this part? try eSpares. Bosch parts are expensive but alternatives are usually available. They also have video tutorials
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
...control board, if these check out replace the latch assembly." Since you've already replaced the mechanism then it seems possible a loose -connection- may be your problem. If you've already checked ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions