Questions & Answers for: replace clutch master cylinder 2001

...Master Cylinder, Clutch, Pressure Plate and Release Bearing were changed a year ago. I have the Master Cylinder adjusted out to it's max, and I've tried everything in-between and the clutch pedal is ...

...clutch was engaging at the very top of its range of motion.... Checked the master cylinder reservoir, it was low, but not empty... I added a little fluid, noticed the cap doesn't fit tightly. Checked ...

...clutch why fool with this, ??? it needs a new MC or slave or both. if the MC is dry both ends not dripping, on fire wall it might be ok? and only the slave bad. but why play games here. are you ...

...return on isuzu rodeo truck Your clutch slave and clutch master cylinder probably has a leak. When you find which one leaked, replace both. If you replace one, you'll be doing the other shortly

...clutch twice, the master cylinder, and the slave cylinder. The only time it slips is if it has been driven for a long time or if it idles for more than a few minutes. I have bled the clutch a few ...

Clutch will sometimes go to the floor and stick. I have tried bleeding the line. The thing I noticed is that when I added clean brake fluid in the master cylinder is turns dark. Could this be a seal ...

How many places can clutch fluid leak from on a 1996 isuzu rodeo 4x4 5 speed. The master cylinder and the slave cylinder and of course the pressure line connections.

...or replacement. (Not disengaging the trans fully). Check to make sure you have enough juice in the clutch master reservoir and that there isn't a leak at the clutch slave cylinder

...master and slave cylinder for 1993 Rodeo clutch. While bleeding never got pressure in pedal, have fluid leaking need to know how the lines run around engine to find leak. Did you bench bleed the ...

a 1998 rodeo I have to bleed my clutch because of air bubbles The brake master cylinder is directly in front of the steering wheel. If there is a hydraulic clutch the clutch cylinder should be bear it