...replace the clutch. It turned out the hydualic fluid was low. The fluid is for the slave cylinder that controls the clutch. If it is low the clutch will only be partially working. It is locating by ...
...replace the clutch or if it's easy enough if I can replace it myself? Hello; First congratulations on buying a camaro. If you have the clutch replaced, cost is in the $500. range. Can you do it ...
...clutch and pressure plate Did you bleed the system? When you replace the the master and/or slave cylinder you have to bleed the system just as you would with brakes. There is a bleed screw on the ...
...camaro hydraulic clutch problems, so i have converted it to bowden clutch cable. But I'M Still interested in how the hell could it work right? The easiest way to bleed out a clutch hyd system is to ...
...Replace Clutch Master cylinder honda civic.... replaced with new clutch and clutch kit... now i have to replace the clutch master cylinder..... only done 167k since new clutch.... should this have ...
clutch or should i replace it now before i have to pay for a tow. Camaro is a 3.4ltr v6 problem just started last night. i was in fifth gear about to exit highway on coming car sped up and then slowed
Question about 2000 Camaro
...camaro z28 clutch has no pressure when i replaced the slave cylinder? did you bleed the slave cylinder when you replaced it? if so check the clutch master cylinder it could have bad seals and the ...
Question about 1998 Camaro
...camaro v6 manual hydraulic clutch line keeps disconnecting itself I ve got a 98 camaro v6 3.8, its a manual transmission. The Steel Braided Hydraulic Clutch line keeps popping out of the slave ...
Question about 1998 Camaro
...replacement clutch master is not defective, you may need to replace the slave cylinder located at the transmission. Bleeding of the clutch system is done at the slave cylinder. Hope this was
Question about 1996 Camaro
Camaro 96 3.8 clutch pedals are suposed to go all the way to the floor , you sure you dont mean brake pedal (cus thats bad ! ) clutches should travel all the way to floor and release the "grab" of the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
