...replace it. They will be located in your exhaust system. At least two of them, one before the catalytic converter and one after. You will see a wire going to each of them. It will be the only thing ...
...nissan quest we have had a tune up, waterpump, fuel filter, front/rear catalyt converters replaced, battery replaced, transmission speed sensor replaced - it is sputtering and cutting off while ...
...replace exhaust system on 1998 nissan quest TRY AND GO TO DIFFERENT GARAGES AND SEE WHAT PRICES YOU GET IT DEPENDS ON WHAT YOU NEED ABOUT $200-$600 DEPNDING ON WHAT PART YOU NEED MUFFLER,CATALYTIC ...
...Look for the oxygen sensor on your exhaust system....most likely on the catalytic converter. Unscrew it and unplug it from it's harness. Screw in the new one and plug into the harness.
...catalytic converter. Ho2S 2 signal is less active than signal produced by front oxygen sensor. This code sets when HO2 Sensor voltage is greater than 999 mV for more than 2 minutes (time depends on ...
...for poor performance of the catalytic converter on bank one which could also be the sensor.I would probably replace the sensor or switch it with the one on bank two and see if the codes
Question about 1997 Quest
...catalytic converters,replaced the fuel filter, replaced the rotor button and cap. When your engine is cold it runs in open loop, and bypasses the oxygen sensor. When warm it goes into closed ...
Question about 2000 Quest
...catalytic converter/s. Have the codes read. repost. It the ignition coil inside the distributor. I have the same problem with my 2000 Nissan Quest. After I replace the distributor, my car runs great ...
Question about 2004 Sentra 1.8
...catalytic converter and the car ran great for just a couple of days. It is now not going over the speed of 15 miles/per hour what is our next troubleshooting step? at first the rpms revved up really ...
Question about 2004 Sentra 1.8
...is plugged Check Catalytic converter by removing O2 sensor temporarily...if it runs properly, replace catalyst...if it does not, check and clean, IAC valve and MAF sensor...use MAF cleaner
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions