Questions & Answers for: replace cam position sensor 1992

...cam sensor it is easy to replace, passenger side of engine on or near timing chain housing, however, if the cam sensor magnet is weak it too must be replaced, which involves removing the timing gear ...

...outta gas never started.its not fireing. tested coil packs they good. changed: cham sensor/crank sensor/ECU(computer) why my 1992 oldsmobile 88 royale ls won't start after I put the crank sensor ...

#19020 in 1992 oldsmobile,eighty-eight,v6-3.8l engine The cam sensor is just under the water pump. The magnet is on the cam gear, To replace it the timing cover has to come off along with the cam gear

...change the cmp sensor and the problem continue.thanks You need to replace the pick-up magnet for the cam sensor. It is pushed into the cam gear. You have to remove the timing chain to install

...1992 olds royale,3.8, suddenly shuts down while driving. Car can be restarted right away. No other signs, no warning. Fuel pump? car starts and idles good.it cuts off while driving,and starts right ...

cam sensor located? the cam sensor is where the distributor used to be. see pic below The cam sensor is located under the waterpump, if you look right under the pump you will see the sensor, to remove

...what position the camshaft is in .The cam sensor is located on the front of the timing cover midway up the front of the engine. be careful and check that the magnet did not fall out of the cam ...

...replace the coolant sensor; that code sets whenever the sensor is disconnected and the ignition is turned on; and it needs to be reset by disconnecting the battery or with a code reader. anyway, the ...

...1992 oldsmobile 88 royale need to see if new wires are correct on 1992 oldsmobile 88 royale This is an explanation of the entire ignition, but includes wiring for the V8 Ignition Systems Short Course ...

cam position sensor location this sensor is located on the timing chain cover at the top. it has a plug connected to it.