...cluster with care when you remover it. if it was my car, i would replace all bulb. there are several different light bulbs for each indicator. one bulb has blown. replace bulb and problem
My headlights wont come on My headlights wont come on , the bulbs are not blown out and the fuses are in good shape. I was trying to figure out exactly what the problem could be. I changed the ...
the dash lights related to the emergenct brakes come on and off, the brake lamps indicator stays on and the ABS now and then. The trunk gets water when it rains and I think it leaks around the tail ...
I have a 1994 acura vigor. the dealer replaced 2 I have a 1994 acura vigor. the dealer replaced 2 rear bearing assy. claiming there is a ring on bearing that the sensor reads for the abs braking ...
How do you reach and replace the brake switch? usually is right in front of the pedal arm, move seat back and disconnect the connector, then it should screw out, replace in same order
break lights will not go off even when car is off It should just be the brake switch as long as the bulbs are good.It is usually attached to the linkage up higher on the brake pedal.It may be ...
how to replace the fuel pump on acura vigor 1992 YOU HAVE RELIEF FUEL PRESSURE BY REMOVING GAS CAP THEN LOOSEN SERVICE BOLT ON TOP OF FUEL FILTER ABOUT A TURN.WHEN FUEL PRESSURE RELEAVED.THE FUEL TANK
replace brake light switch replace the switch the switch is located just above the brake pedal
what are grounds brake lights want work most car mfg use the car chassis as a "ground" (saves wire) a simple voltage tester from about any autoparrts store cost's less than ten bucks , grounding the ...
how to replace the rear main seal on a 1993 acura vigor? how do I replace the rear main seal? This requires removal of the transaxle, which on this car is a very long process, pays about 10 hours or ...
Usually answered in minutes!
135 Questions
72 Questions