...brake assembly and/or to replace the snubber. There is a 200lbs spring located under the Brake Stator that must be compressed PRIOR to removal or you could cause injury to yourself. You can find all ...
brake assembly and/or to replace the snubber. There is a 200lbs spring located under the Brake Stator that must be compressed PRIOR to removal or you could cause injury to yourself. NOTE: There should
...snubber is item 24. The brake stator is item 25. This can be a challenging repair is you've never worked on a washer before. Now, if you wish to pursue this repairclinic.com is another reputable ...
...replace the snubber and brake assembly: 1. Remove the front case of the washer to access the washer interior. 2. Tilt the washer towards the back and remove the drive belt. Slide the drive motor ...
...brake accessible by taking the front panel off? Thanks Joe Here's the same advice I gave another person with a similar problem to yours. The squealing can be caused by the brakes, or a worn snubber. ...
Question about Atlantis MAV9750A Top Load Washer
...replace the snubber and brake assembly on your Maytag washer, just follow these steps: 1. Remove the front case of the washer to access the washer interior. 2. Tilt the washer towards the back and ...
replace the brake assembly on your Maytag top loader WITHOUT the use of special tools. This is not that difficult of a repair either. To replace the snubber and/or brake assembly follow these steps: 1
Question about Atlantis MAV7551 Top Load Washer
...brake stator, and snubber ring on a Maytag MAV7650AWW top load washer. Now, when it is running it makes a loud grinding or humming noise. Nothing appears to be leaking. I ran it with the top off and ...
Question about EPIC MFW9700S Front Load Washer
...replace a snubber in my capacity plus admiral. Any snubber video would be helpful. I'm assuming that since you mentioned a "snubber" that the washer you are referring is a Maytag manufactured top ...
Question about Atlantis MAV6000 Top Load Washer
... brake stator, brake rotor and lining and snubber? one of the above. Tip the washer back and turn the main drive pulley while spraying a little WD-40 in there. That will quiet down the washer.More ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions