Questions & Answers for: replace blade andis clippers

Andis Masters 1)are not cutting properly. I have replaced the blades and they basically pinch and pull. 2)The clippers slide out of adjustment settings.3)The clippers also get hot in a short amount of

...replace. This Lever moves the blade side to side fully. if the Lever is worn the blade will not move fully side to side and the cutter blade the smaller blade will stay in the middle with hardly no ...

...andis agc2 clippers will not cut hair now.They are also a little noisy.The blades have been sharpened and are oiled. Providing the clipper blades have been correctly sharpened try replacing the blade ...

...Andis consumer hi, new blades are not the answer try replacing the blade drive assembly which is located at the drive end of the clipper and goes from side to side, as the clippers are used this part ...

...like the blades need to be sharpened, refer to the shavers brand name plus .com for blade replacement or replace the shaver. you can check this

replace that piece or the entire blade. Just don't bend those pieces too much or the blade won't snap back on your clippers. If it is a loose screw tighten them all but don't over tighten or you could

...lines like if my blade was dirty. I make sure my blades are clean and when I switched clippers.. I had no issue with lines. Sounds like it's time to replace the clippers with something much

andis clipper blade I can slip the blades on, but it will not lock the blades in place. I can simply push the blade backwards and it will come off. I have replaced the Blade Drive and it did not help.

Andis Clippers not locking I have replaced the blade drive. I just bought my clippers and they will not lock my blades into place. When I put them on I can still take them off by simply pushing ...

...will mean all blades have the same problem) or the blade socket on the blade may need adjustment or replacement. Please view the part in question ...