ge spacemaker the inside light on my microwave oven stoped working where the hell is it located remove the front vent cover above the door - light is inside
cover that the vent door conects to is broken. It is not obvious how the plastic cover is attached but I'm guessing it is just snapped in. How do I remove the plastic cover?... thanks Be sure the oven
...removing light bulb microwave fritzed out, no power anywhere, is there a fuse that can be replaced yes there is. the fuse should be located behind the vent grill on the right side above the control ...
...vent off by removing the two screws at the top front of the oven. I could pull the active vent forward, but it did not come off. I was worried that I would break it. How do I get at the bulb to ...
Question about JVM1790 1000 Watts Convection / Microwave Oven
...vent cover forward at the top. Sliding left is sometimes necessary to release the bottom tabs of the vent cover. The light fixture will be behind this cover. Good Luck. Reverse the above process to ...
Question about Spacemaker JVM1640SJ Microwave Oven
...is not installed at this time), the vent still won't come off. Even though it is not 'installed' there is potentially lethal voltages stored in a large capacitor so do not remove the outer
Question about Spacemaker JVM1640SJ Microwave Oven
...vent cover and there may even be some on the top cabinet holding vent cover on front, then you might see fuse holder just behind vent cover, if not remove screw(s) holding touch pad on, then slide ...
Question about Advantium 120 Convection/Microwave Oven
...vent cover, I would test all cavity switches before removing from wall. You should have a diagram of unit folded up behind vent cover towards right side of unit. This tells all workings of unit. Will ...
...vent to the left, it will move about 1/8" just enough to unlatch it and you can remove it. Your light bulb is hidden under a metal tin cover. Depress a small plastc latch in front of it and lift the ...
Question about Spacemaker JVM1640SJ Microwave Oven
...vent cover. W/ cover off you will find a phillips head screw about the center that holds the bulb cover. Remove the cover screw & lift up & remove the cover, then replace the bulb, the cover ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions