...so that they cannot get to the reset button. Their only option is to open up a wall, possibly from another room so as not to ruin the tile job. It mean tearing up the tile to get to
...shower or a wall you may be able to get to the diverter without damage to the tile ,are you sure you can't just change the cartridge? most times this is all that is needed to fix a problem like
...tile and try to remove it to be able to start. Be careful not to brake the plaster, this is the biggest problem when removing wall tiles. Keep hammer the chisel, and remove bit by bit all the tiles. ...
wall behind the tile might be water-resistant drywall (a poor quality situation) or it should be cement-board. I suppose it's possible that there is already a hole in the wall behind the tile, but
I have noticed blue mold in my basement coming from behind the area that has wood paneling, but also around the entire edge of the floor even where the walls are concrete (both interior and exterior ...
Question about YouTube Videos
tile. Fasten the wire to beams in the wall. The wire will hold the plaster in place. Let dry, sand smooth then paint. If you have sheet rock walls measure the hole cut the sheet rock to fit. Fasten it
Question about YouTube Videos
wall base. problem usually happens when grout is not fully cured and sealed when water penetrates it so... remove old grout using grout removal tool (you can pick up from any where that sells flooring
Question about YouTube Videos
...wall tiles were not installed by the builder not accounting for heavier than normal load. If by chance the washroom is in the basement:: Non-load bearing walls (interior non-loading will be supported ...
is there any way that a paint be removed easily on tiles my tenant painted the walls tiles of the toilet Well, The easiest way to eliminating dried on paint from tile is to scratch it off utilizing an
Question about YouTube Videos
How can I safely remove chunks of dried grout from my sistine stone shower walls and floor? Also, my husband grouted too wide in some parts and I need to remove some from the sides of the lines. ...
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions