...Removing the rubber mat should expose a hole cut into the plate. Turn the plate until you see the short beveled rod sticking up. Take a toothpick or something and pull the band from around the bottom ...
metal cover from the player to access the tray mounting screws in the black plastic tray frame. By tightening or loosening the little screws on both sides of the front of the tray mechanism, I got the
...metal cover over the drive and the outer cover of the unit. Straighten a paperclip. On the face of most disk players there is a small hole. Push the paper clip into the hole, and the disk tray should ...
...clip? This is the common means of opening a tray - best done with the power off. Sometimes you can press open and then use a metal nail file to pry at the opening between the tray and player until it ...
I have a 6 year old Panasonic DMR-50 and recently it has been displaying No Read on the faceplate and not compatible disk on the screen. I have tried both the Maxell and Memorex -R Dvd's and they both
...clip at the base of the post that holds the metal plate on, remove that , you will see the motor shaft, and the ridge on the underside of the metal plate that the belt has to be on, they sometimes ...
clip with a flat head screwdriver and remove pladder,"may take some wiggling to work it loose because the grease is like dried rubber" When pladder is removed be carefull in taking out the metal ring,
...clip will go flying. On the other side, the entire metal plate can be removed and the record player can be disengaged by disconnecting the plastic harnesses for the audio and the elec for the motor. ...
...the player cover and on top of the drive is a 3 X 3 (approx) metal plate with a plastic wheel visible in it. Un clip the two sides of the metal plate and it will pivot up and the disk can be
Question about LVW-5005X DVD Recorder
...metal cover. Note the position of cover before removing the four screws. Use thin nose pliers to remove fuses from fuse clips. It's easier if you disconnect the black and white connectors on circuit ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions