Questions & Answers for: removing ignition cylinder 1998 cadillac

ignition wires on 1998 Cadillac De Ville I am replacing the ignition wires. How do I gain access to the odd numbered cylinders? What parts need to be removed and in what sequence? Any words of caution

CAR SAYS STARTING DISABLED REMOVE KEY Boken wire on the ignition lock cylinder. Replace the ingnition lock cylinder Problem Solved. [email protected]

ignition lock cylinder, the wires that give the signal to the computer that allows the engine to start and run are broken where they leave the lock cylinder. To replace you need to remove the steering

...cylinder, then you can save it with this Full Bypass. Trucks . GMC/Chevy 1998-2006 S10/T10/Sonoma /Blazer/Jimmy 1998-2007 Suburban/Avalanche /Tahoe/Yukon 1998-2006 Sierra/Silverado 2002-2008 ...

...ignition switch (expensive) or bypass the module (easy and inexpensive)-I have done lots of these, requires about 15 cents worth of parts and can be done in 1/2 hour. If the headlights are flashing, ...

...ignition or starter disabled due to theft system. What causes this? It's when the security light starts flashing that the infamous "chip" in the key becomes a nightmare to many. Gradually the car ...

...ignition cylinder still says wait three minutes to start It's that infamous "chip" in the key that becomes a nightmare to many. The security light may or may not start flashing. Sometimes it stays on ...

...ignition misfire, and almost always was is a plug cable. Since you have COP's (coil on plugs) on the 4.6 Northstar, it is probably a little more complicated, especially if you are not getting a ...

...ignition key. Your car is equipped with the VATS security system which requires a key with a resistor attached (small chip). Over time the sensor inside the cylinder will not recognize the key. ...

...start You likely have a faulty ignition lock cylinder or a problem with the body control module. For some reason, the vehicle thinks it's being stolen and has disabled the starter and the fuel