...remove the wiper arms off of the wiper pivot. Is there a special tool needed? Is their a simple method? loosen the nut on the wiper arm and gently pull on wiper arm and hit the nut with a rubber ...
wiper linkage on a focus. when you switch the wipers off they remain half way across the window.when they are on they work fine, they dont hit the sides or anything so i presume i have them set right.
...remove the wiper arm L&R using the corresponding spanner.open the cowl plastic cover by removing the screws along the sides.upon removing the cover you can access the wiper motor and ...
...to it, the arm mechanism, and make sure it is not hitting anything while it is in motoion. Not familiar with this cars set up. Remove wiper blades, or stand them up and see if it still blows tyhe ...
...not is this abig problem the wiper motor arm might be the problem check for the rear wiper arm or rear wiper trans arm link. will have to remove the backing in door in order to change it. good ...
realigned LOWER WINDSHIELD COWL DRAIN STOP UP WITH LEAVES OR WINDSHIELD SEAL LEAKING.THE LOWER COWL HAS TO BE REMOVED TO CLEAN DRAIN HOLES OUT.YOU HAVE TO REMOVE WIPER BLADES ARMS TO REMOVE LOWER COWL
...wiper arm. There is a plastic cap you remove and under it is a nut, and if it's loose, you need to get the wiper motor to park...by turning on the wipers, and then off and wait untill it sounds like ...
...the plastic cover under the windscreen ,remove the wiper arms then the torx headed screws and away you go shouldnt take more than 10 mins to gain access even for a novice weekend mechanic to ...
...remove the wiped arms, the remove the wiped cowl. The wiper cowl bolts are located under the hood and screws through the spaces in the cowl. Reconnect linkage, reinstall cowl, reinstall wiped
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
