...remove the angled cover below dryer as Washer Door lid assembly is wholly below. Just push the dryer toward the rear, then remove two larger nuts from top left and top right corners. No nuts at rear, ...
Question about LTE5243D Top Load Stacked Washer/Dryer
...washer to fix the lid switch without pulling it out of my closet?? Please help. Thanks for your help. the lid switch can be changed without removing from closet for sure,you can remove the angular ...
...washer/dryer. (Model # LTE6234DQ1) I wish to move it down a flight of stairs and want to know if this model can be easily 'unstacked' for the move. Thanks for your help. Hi there. Yes it can. Access ...
...lid forward than remove lid switch connection right front corner,,now the tops off...remove the 2 screws holding washer front panel..now your in ,,to put back reverse...att'' always unplug unit ...
Question about WD-16115FD Front Load Washer
...Remove the top of the washer by removing the 2 retaining screws (phillips head) from the back of the unit & sliding the washer top back about 2" & pulling up. You will see a white detergent ...
...Remove them. 2. Next open the washer lid. There will be two screws on the right side. Remove those. 3. Close the lid. There are two final screws that hold the top part of the washer in place. You ...
...washer lid. Remove them and you will be able to access the washer controls. Before you go working on the parts, to remove the control timer, please unplug the stacked washer/dryer combo and turn the ...
Question about 98702 Stacked Washer/Dryer
...remove the front of the washer by pushing the panel down to release it. ( about 1/2 inch). Once the panel is off you then remove a screw under the top of the washer at the front on each side. The lid ...
Question about LTE5243D Top Load Stacked Washer/Dryer
the washer top off the unit.Remove the two screws from inside the top of the washer front panel.Lift up on the front panel to release the catches near the bottom of the panel andremove the front panel
...Remove stacking kit from top of unit. 2 Reatach the two plastic clips to the back of washer. 3 engage the two slots on the washer top into the clips , pull forward drop lid down on top of washer then ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions