Questions & Answers for: remove valve cover mitsubishi galant

...remove the upper timing belt cover and do this quick inspection with someone that will tell you for sure. if it does look like it is spinning then by hand turn engine very slowly with plug coil wires ...

Ad

Question about 2002 Galant

1 Answer

location of a sensor need to know the location of a crank shaft sensor on a 2002 gallant with 2.4L 16 valve Replacing a CPS can be easy or hard. On the 2002 Gallant 2.4, it is located behind the ...

Ad

...valve gear rockers etc. To push in tensioner put it in a vise and SLOWLY wind in There is a small hole near piston end of tensioner that you have to line up with piston and put a small allen key or ...

free how to change spark plugs on a 2000 mitsubishi galant es 4 cylindeer You have to pull the spark plug boots out of the valve cover and use a long extension with a spark plug socket and remove them

...valve cover and the air filter housing. No worries, just remove the bolts, and remove the old gasket around the cover. Upon installing new rubber gasket, make sure it is clean. Put a silicone sealant ...

i need to know what to take off to remove valve cover to change the gasket. you take off the valve cover. the valve cover is usually where the oil fill cap is located.

...valve cover, This type ignition system is referred to as a "Direct Fire" igntion system for obvious reasons. Remove the coils (one for each engine cylinder to access the plugs. See picture of coil ...

Question about 1999 Galant

2 Answers

...valve. Remove the heated oxygen sensor plug and the Differential Pressure Feedback EGR (DPFE) sensor. Disconnect the ignition coil with power transistor and its wiring and bracket. Remove the valve ...

Question about 2002 Galant

1 Answer

valve cover from there and remove the same as any plug will. I really recommend using a high quality plug. For the V6 you will have 3 plugs on the firewall side (under the manifold) and 3 plugs on the

...your help.!!!!!!!! The pcv valve will be on the valve cover. It will have a tube coming to it. You can pull it out to remove it. Shake the pcv valve, if it doesn't rattle, it needs to be

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...