...remove the taps off the two screws/think they are gold/have white wire guides stuck on them. then go outside and pull on taillight assembly. taillight bulb is second up from bottom. pull out/replace ...
...Brake Lights are stuck on....the ABS comes on the dash intermittantly, could this be 2 seperate things? Brake Light switch and the ABS Sensor(s)? Any Advice? CHECK YOUR FUSES I HAD ONE WITH A BLOWN ...
...stuck on it could be caused by the earth or grounding is faulty may just need to remove bulb 7 put it bak in it may fix it & the warning should dissapear my advice is to get someone to press the ...
...stuck on the fluid resovor is it? You may have bad connection or faulty bulb. Remove and Check the the taillight assembly for any water condensation near the bulb socket, check all grounds, check the ...
Question about 2001 FLHR - FLHRCI Road king
...remove the bulb, spray some WD40 in the socket, check the spring at the rear of the base contact point( might be stuck ). Over the years rust and oxidation usually accumulates in that area and needs ...
...remove and replace the left rear brake light? Hi there, This is quite easy. Firstly, you need to open the back gate and unscrew the rear light panel, and then replace the bulb. But be careful, it is ...
...just get stuck, so depress the brake and see if the switch is moving at all, if not, remove the switch and replace it as long as the adjustment looked to be correct. faulty brake light switch you ...
remove the bulbs. Any suggestions ? Are you sure it is the tail lights, or could it be the brake lights? If it is the tail lights, the light switch should be replaced. If it is the brake lights, there
Question about 1991 Pickup
...Brake switch is stuck in closed position. Or get yourself a schematic, examine the brake light connection to the power line and you will see the possible causes of the anomaly. Or a wire that is ...
...any hints that would be great It probably is stuck due to corrosion. You might have to replace the bulb and socket. You could try spaying WD-40 on it and wait awhile and the try to remove it
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions