Questions & Answers for: remove steering lock pontiac grand

Question about 1997 Grand Prix

1 Answer

...lock cylinder over with a wrench or something. Anyway, the gears on the inside fell out all over the place when I removed this housing unit. It is made of lightweight alum, and has 2 sets of numbers ...

Ad

Question about 1997 Grand Am

3 Answers

...remove the oilpan without removing the motor? By the way i have a 1997 Pontiac Grand Prix SE no the wheel bearings are not broken your steering rack and the water at you tail pipe is condensation ...

Ad

Question about 1997 Grand Am

1 Answer

...steering wheel and such if you are trying to remove the ign lock cylinder you have to remove the lock plate snap ring, sir coil, turn signal switch assembly to get to the bolt that hold the ign lock ...

Question about 1997 Grand Prix

2 Answers

remove it? Tilt the steering wheel all the way up. Reach inside the hole on the right side underneath the ignition. You will feel a metal button. Push it up, and you'll be able to turn the key all the

...Remove the key from the steering column lock cylinder set (1). Installation Instructions Insert the key into the steering column lock cylinder set (1). LIne up the locking tab (2) and the positioning ...

...steering lock plate, you need a compressor to push it in and remove the snap ring that holds it in place on the shaft, just a thought Hello. I can assist you. The black metal piece that you are ...

...steering column below key and remove. insert small screw driver in hole to depress saftey lock and turn back key. If it's an automatic, try pushing forward (Towards the radio/front of car) on the ...

Question about 1997 Grand Am

1 Answer

...no key Removal of steering wheel is required. Remove steering wheel lock plate, (special tool required) remove 7 mm bolt holding in cylinder. Remove cylinder. Reverse procedure for

...shaft but pushes on steering lock plate, so you can remove retaining clip. Then remove steering lock plate. I believe turn signals come out next. Then just a screw to remove ignition switch I

Question about 1997 Grand Prix

1 Answer

...can put key in run position, I think you would be able to remove lock cylinder. You have to pull the steering column  covers off to remove cylinder. There is a procedure, pretty easy. Good

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...