...sliding door. 3) Using a small flat screwdriver, gently lift the black tab on the catch mechanism and rotate the switch to remove it from the catch assembly. 4) Using a rag, clean the small round ...
switch on the sliding door by removing the panel and wiring the top and bottom wires of the contacts together. Now the computer thinks that the door is always closed. Just make sure you close the door
Question about 1999 Windstar
...sliding door does not engage lock and chatters instead. there is a lock actuator inside the door these can be bought relativlyy cheap at the parts store the easiest way to replace is to remove the ...
Question about 2001 Windstar
...remove the door panels to check the problem and what is the most likely fix? The door lock actuators or 'solenoids' have failed. This seems to be pretty common on Windstars - I've just replaced a ...
sliding rear door lock does not unlock completely. unlocks and then relocks itself when using either clicker or door locking switch. Any suggestions? This is an adjustment best done by a professional.
...remove the side sliding door from a 1998 Ford Windstar? To prevent damage to the vehicle, two people should perform this procedure. Remove the interior trim panel. Remove the bolt attaching the lower ...
...sliding selector switch . Any ideas ??? Your blend door actuator is stripping it's gears. The actuator is part #14 in the diagram below. You may have to remove a finish panel to access the actuator. ...
...sliding trim away from latch. Remove portion of armrest containing door lock switch and window regulator control switch (14529) by pulling straight up. Remove rear view outside mirror mounting hole ...
...Remove interior lamp relay. Measure voltage at interior lamp relay connector Pin 87, Circuit 53 (BK/LB). Is voltage greater than 0 volts? Yes No SERVICE Circuit 53 (BK/LB) for short to B+. RESTORE ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions