...light bulb/s on the getz is easy just open rear hatch then you will see 3x pozi drive screws alongside each lamp assy that screw /secure the lamp to body at the lower endof drain channel? remove ...
Question about Motor 2003 Elantra
light cluster just seems to wobble a bit. On the Getz remove 2 screws on the outside then gently prise the cluster off from the dowels as above. if you look inside the tailgate to the cluster you need
...(LH and RH side of this assy). remove the covers and using a phillips screwdriver, remove the screws and lift the assy up and away from the rear glass. you now have access to the bulb and
...remove the tail light cluster to replace the bulbs. This is the position on most sedans, unless, like on pick-ups, the tail light lenses have screws which allow the lenses to be removed to change the ...
getz light fuses Which fuse do i need to check for my 2003 getz 1.1 gsi the bulb is ok so i assume it must be the fuse could be.your fuse, could be broken ground, bad bulb socket, did you check to see
Question about Motor 2004 Accent
...blown. Some of the lights are double duty, so the brake light might work, but the flash side might not. Change all brake lights and turn signal bulbs. 98% sure if you change all bulbs, it will
...light globe on 2008 hyundai getz Remove the two 10 mm (head) bolts that hold the stop light. This bolts are between the tail light assembly and the tail gate weatherstrip. You can see them without ...
Question about 2007 Getz 1.4
The main beam drivers side not working properly there is power going through the bulb it lights up but not enough for a beam any help please. Changed the bulb twice no effect checked and changed fuse ...
how to change tail light hyundai getz tail light http://hyundaiclub.co.uk/diy-guides/getz-diy-guides/how-change-getzs-rear-light-cluster-bulbs/
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions