Questions & Answers for: remove rear break drum

remove the drum on the rear breaks. the Haynes manual has wrong photo & instructions. (Haynes has photo of drum with four bolts attached) The replacement drum I purchased from Rock Auto has five holes

Ad

...rear brakes and/or slacken off the park brake cable to remove the drum as the chances are the drum has a wear lip that the shoes are getting hung up on. ( first make sure there isn't a little ...

Ad

...remove. ) Jack up the rear wheel. ) Check to see the wheel will turn so you know the brake shoes are not binding against the drum. ) Now you can remove the lug nuts and wheel. ) Remove the drum. Some ...

...remove the rear drums and adjust for proper clearance (there should be no drag with drum breaks. If they are disk breaks I'd say the calipers are stuck and keeping tight on the discs; if this is the ...

...remove right rear wheel to check brake shoes. big central nut hard to remove. You do not need to remove that nut to check your breaks. That nut removes the whole hub assembly. Don't mess with it. Now ...

Question about WA 125 Front Load Washer

1 Answer

...can break , it is not unusual. Remove rear cover, and looknunderneath the drum, you will probably see where it has broken, and it would be better to buy new washer if it has brokem. Happy new

...rear brake durms are two pieces, make sure there are no lock clips over the studs which i dont think there are on this 1993, these drums sometimes are tough to remove off the hub, spray wd 40 around ...

Question about 1993 Grand Voyager

1 Answer

...Remove rear wheels and then remove rear drums. You might have to pound on the drums with a hammer to break them loose fromthe axle shaft. Pound in between the lug nuts to loosen the drums. Inspect ...

...remove the rear brake drum on a chev 3500 4x4 Unless this truck was designed different from all the rest? It should be has simple as pulling off the tire and tapping around the back edge of the drum ...

Question about 1996 Escort 4 Door

2 Answers

rear tire won't turn. how can I break it loose un do the adjustment . remove any retaining screws in the face of the drum. Use a hammer and hit between the wheel studs. hit the drum back onto the axle

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...