...remove the radio from a pontiac montana 2003 and i dont know how to remove the console .Can you show me adiagram? there are 4 screws. two in the front behind the cup holder and two up underneath in ...
...radio code to have it work again. You have to remove the round bar on the passenger side. There are two bolts in front and one in the back by hood hinge. The round bar slides out of the relay box. ...
...radio out. Got 4 of the 6 screws out but not sure on how to remove cup holder in the dash to get to 2 other screws? Help!!! Pull the cup holder out, then push it in about 2 inches, then push it DOWN ...
...2003 Montana and now my dash guages are dead. There was no short involved--only a simple battery re-placement. The radio also went into "lock". The radio will go to lock when the battery ...
...remove the radio to either repair or replace it? The posted directions given for the 2003 model do not seem adequate. See if there are small holes on each side of the radio. If there is slip a paper ...
...RADIO AND REMOVE THE DRIVE BELT AND REMOVE THE NEGATIVE BATTERY CABLE. REMOVE THE STARTER SO YOU CAN PUT A LARGE SCREW DRIVER OR LARGE PUNCH TO STICK IN ONE OF THE FLY WHEEL HOLES TO KEEP ENGINE FROM ...
...remove the old one and then check at the parts store to ensure you are replacing like for like with the correct sensor as different states have different emissions laws that effect the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions